Modular Organizer (optimized for spiral vase – low materials utilization)

Modular organizer, created and optimized for very low filament utilization. After printing the components, glue them collectively utilizing any sort of plastic glue. I personally used clear twin composite epoxy from Bison, however I assume any glue might work, together with CA.

If you’re desirous about extra comparable designs, please go to my profile at: https://cults3d.com/en/customers/taciucmarius/creations

Have enjoyable printing it and publish makes once you do.

It will possibly both be printed as spiral vase (spiralized contour) or printed with no infill and no prime layers for facilitating 2 or 3 partitions.

Advisable :
– 0.2mm layer peak
– 3 backside layers,
– if printing as spiral vase, you possibly can improve the extrusion width (line width) to 0.5mm when printing with 0.4mm nozzle. This shall improve the layer bond and the general energy of the construction.
– Be careful for elephant foot. If this occurs, it is going to make it tough to stay the cell items collectively. You may compensate this impact out of your slicing device or you possibly can sand it down later.